|
|
|
|
|
 |
•
•
•
•
•
•
•
•
• |
Catalogues |
» STOCKS » Service Equipment » Lifting Equipment |
JIG is a quality ISO9000 manufacturer and have been in business for over 30 years and export worldwide
| 2 Post Based Floor – Model No TPV209 |
 Genuine 4 Tonne Lift capacity for cars, utes, vans, SUVs & light trucks
Safe & Reliable
Made from High Quality Q235 High Tensile Steel
Single Phase
CE Approved
Overall Height 2.857 Metres
Max lifting height 1.80 Metres
Overall Width 3,152 Metres including posts (2.608 Metres between columns)
Floor Beam Plate is only 35mm high
Includes 4 of each Drop in (swap over) 80mm & 150mm lift pad adaptors for cars /4WDs / Light trucks
Automatic Safety Locks
Automatic Arm Restraints
Cable-equalization system"
Dual Hydraulic Cylinders
Low ceiling design
Maintenance free load bearings
Smart Blue Plastic powder coat finish |
|
 |
| 2 Post Clear Floor (Baseless) – Model No TPO309 |
Genuine 4 Tonne Lift capacity for cars, vans, 4WDs & light trucks.
Safe & Reliable.
Made from High Quality Q235 High Tensile Steel
Available in either Single Phase or 3 Phase
Overall Height 3.750 Metres
Max lifting height 1.850 Metres
Overall Width 3,199 Metres including posts - 2.855 Metres between columns
Telescopic Screw Pad height extensions
3 Stage Asymmetrical arms
Dual hydraulic cylinders
Electronic control system with electronic lock release
Engineered self lubricating polyurethane carriage guide
Micro switch controlled overhead cut-off
Rubber door guards to protect vehicle doors
Audible beeping noise when hoist descends |
|
 |
| Model No FPL 309 General Service 4 Post Hoist |
Single Phase
Ideal for all general service work, WOF shops, Exhaust (Muffler) shops, etc.
Comes complete with one free 2 Tonne Air /Hydraulic Jacking Beam
Safe & Reliable
Made from Thick High Quality Q235 High Tensile Steel
Overall Height 2.176 Metres
Max lifting height 1.80 Metres
Overall Width 3,088 Metres including posts (2.690 Metres between columns)
4 point levelling system
Automatic Safety Locks
Air operated single point lock release
Cable-equalization system
Hydraulic Cylinders
Smart Blue Plastic powder coat finish |
|
 |
| FPL/FPA 412 - 12000LB/5.5 Ton Four Post Hoist |
- 4 point leveling system
- Automatic safety locks
- Adjustable runway
- Alignment operation (FPA4120F)
- Extra wide for 3D alignment system
- Flat deck design (FPL412)
- Hydraulic rolling jack (option)
- Maintenance free load bearing
- Open front design for easy under vehicle access (FPA4120F)
- Powder coat finish
- Strong hydraulic cylinder
- Single point lock release
- Turntable & slip plate alignment (FPA412)
- Overall Height 2.176 Metres
- 5.201 Metres Runway Platforms
Maximum lifting height 1.826 Metres
Overall Width 3.310 Metres including posts
(2.910 Metres between columns)
|
|
 |
Ravaglioli was established in 1958 as a manufacturer of equipment and products for servicing and repairing vehicles. All Ravaglioli
hoists are CE safety approved and are designed and built to exceed the world’s toughest safety standards
| RAVAGLIOLI: KPX 337 Lift |
|
RAVAGLIOLI: 4800 Lift |
 DESCRIPTION:
Two post 3200kg
baseless lift.
FEATURES:
• Low voltage controls
• Lifting height to 2 metres
• High efficiency motor with
thermal probe
• Automatic arm locking
during lift
• Automatic unlocking when arm
reaches the floor
• Automatic and permanent nut
lubrication system guaranteeing
sufficient lubrication during
lifting and descent
• Very low pad with adjustable height – Minimum height 95mm
• Three-stage short arms for asymmetric lifting of large vehicles |
|
 DESCRIPTION:
8000kg, 4 post truck lift with large clearance between posts to allow
for wide vehicles. Ideal for camper vans, mini buses and trucks to 8t.
FEATURES:
• Adjustable platform
• Automatic mechanical
back-up safety
devices
• Mechanical, electrical,
and hydraulic safety
devices on all four
columns in compliance
with safety standards
• High resistant,
galvanised and prestretched
metal cables
• CE rated |
| RAVAGLIOLI: 640.1/640.2 Lift |
|
RAVAGLIOLI: 200 Series Lift |
 DESCRIPTION:
4200kg platform lift.
FEATURES:
• 4.6m platform
• 640.1 series has a flat platform
• 640.2 series has platform with
rear slip plates for
wheel alignment |
|
 DESCRIPTION:
Mobile Column Lifts ranging from 3000kg to
10000kg capacity per column, designed
especially for the heavy commercial sector.
FEATURES:
• Large solid base for maximum
stability
• Electronic system ensuring
synchronisation of all columns
• Simultaneous operation of all
columns possible
• Available in sets of 4, 6 or 8 |
 Stenhoj was founded in 1917. They manufactured their first car lift in 1929 and Stenhoj lifts are now distributed in more
than 80 countries. All Stenhoj lifts are made with superior construction and finish.
| MAESTRO: 2 Post Lift |
|
MAJOR: 4 Post Lift 4030W |
 DESCRIPTION:
3200kg or 3700kg 2 post clear fl oor lift. Parallelogram pick-up lifting
pads can be set from 95 mm to 255mm. This enables the height of the
support plates that lift the vehicles to be adjusted easily, also making
the set up time quicker and much safer especially with 4 x 4 vehicles.
FEATURES:
• Clear floor version with combi
lifting pads
• Twin synchronised motors for quick
efficient lifting
• Double safety nut on carriers and
integral arm locks on all four arms
• Asymmetric lifting arms and a
carriage design that allows for easy
vehicle entry/exit when on the lift
• CE approved |
|
 • 4 Tonne Lifting Capacity
• 22 Seconds Lifting Time – Very Fast
• 3 Metres between columns (posts)
• Wide Posts will not block targets seeing cameras on 3D Wheel Aligners
• 1.820 Metres Maximum Lifting Height
• 160mm Minimum Lifting Height
• 3kW Motor – 3 Phase Power Supply
• Min / Max Pressure: 5 / 10 bar
• 5.1 Metre Platform Length
• Provision for Front Turntables (for Wheel Alignment Caster Swing)
• 1020mm recesses with 3 Fillers
• Rear Slip Plates included (For Wheel Alignment rear adjustment)
• Comes with a 2 Tonne Jacking Beam (Danish Made)
|
| MICRO 20/26: Jacking Beams 2000kg & 2600kg |
|
MASTER QUICK: Inground Lift |
 DESCRIPTION:
Air and hand-hydraulic scissor jacks for use on all platform lifts. These
are available in 2000kg and 2600kg capacities.
FEATURES:
• 2 hand operation
• Retaining device
• Lifting height -
Micro 20 300mm -
Micro 26 250mm
• Delivered standard with a full set of lifting adaptors
• CE approved and TUV certifi ed |
|
 DESCRIPTION:
Twin ram underground hydraulic lift allows easy access to wheels
and underbody making it suitable for all kinds of repairs.
FEATURES:
• Lifting capacities of 3000kg, 3500kg or 5000kg
• Allows maximum access to vehicle
• Alarm signal on lowering. (3500kg models)
• Flexible usage with optional movable lifting supports
• Available as either drive over platform or movable arms |
ROTARY is the World's Most Trusted Lift - Refer www.rotarylift.com for more info
Rotary Lifts are chosen by FORD USA as their preferred hoist - so they have to be good enough to meet their standards.
| Rotary - 2 Post Hoist |
CLEAR FLOOR - 4.5 Tonne Lift Capacity
Electro-Hydraulic
Built in Rotary's plant is Madison, Indiana, USA
FULL 2 YEAR WARRANTY
Made to American Lift Institute Standards.
Genuine 10,000 lbs (4.536 Kg) Lift capacity for cars, vans, 4WDs & light trucks.
Very Safe & Extremely Reliable.
3 Phase Power Supply.
Grey in colour
Overall Height 3.589 Metres.
Maximum lifting height approx 1.9 Metres
Minimum Height only 93mm - great for lowered vehicles
2.727 Metres between columns - great for wide vehicles
45 second lifting time
3 Stage Asymmetrical Front Arms |
|
 |
| Revolution - 4 Post Hoist |
The RFPA features a 7000lb jacking beam
| Specifications |
RFP14 |
| Capacity |
14,000 lbs. |
| Rise |
73-3/4” |
| Overall Length |
246” |
| Maximum Wheelbase |
180” |
| Overall Width |
137-1/4” |
| Overall Height |
88-3/4” |
| Width Inside Columns |
114-1/4” |
| Length Between Columns |
189-1/4” |
| Runway Tread Width |
20” |
| Width Between Runways |
43” |
| Runway Height |
7” |
| Rise Time |
65 seconds |
| Voltage/Amps |
208/230, 20 amps |
| Motor/Phase |
2 HP/1Ø* |
|
|
 |
Established in 1977, Carleo are committed to devoting their efforts to research and development, keeping in mind at all times the need to produce the best products for their clients future use.
| CARLEO SL 562: Scissor Lift |
DESCRIPTION:
2500kg Electro-Hydraulic Portable Floor Lift.
FEATURES:
• Air pressure automatic safety lock device
• Minimum height 105mm
• Maximum height 870mm
• Single Phase
• Lift time - 30 seconds approximately |
|
 |
| CARLEO SL 568 H: Scissor Lift |
DESCRIPTION:
3500kg, In-ground lift.
FEATURES:
• Electro-Hydraulic
3 Phase
• Maximum height 1800mm
• Lift time - 45 seconds
approximately |
|
 |
MAHA has over 35 years of proven expertise in the fi eld of vehicle lifting technology. MAHA offers a range of lifting equipment for
all types of vehicles.
| MAHA: Duo Scissor Lift |
 DESCRIPTION:
Duo scissor lifts available in 3500kg or 4200kg with optional
platform styles and accessories.
FEATURES:
• Easy and safe access with no stumbling hazard
• Variable installation width
• Electronically controlled service and safety functions
• Both platforms independently adjustable
• Manual lowering function
• Maintenance free cylinder system |
|
 |
| MAHA: Pit Jacks |
|
MAHA: Pit Jack Optional Accessories |
 DESCRIPTION:
MAHA Pit Jacks have a load
capacity of up to 20t and are
either manual hydraulic with
pneumatic or electric power
options.
FEATURES:
• Ram travel options from
450mm to 750mm
• Hard chrome plated ram
• Space saving design
• Manufactured to customers
requirements |
|
 |
OMA, an Italian based Company have specialised in the manufacturing of high quality, reliable garage equipment since 1967.
| OMA 541: Jacking Beams 1500kg |
|
OMA 542: Jacking Beams 2000kg |
 |
|
 |
|
|
|
|